<p><strong>Water-Based Release Agents</strong></p>
<ul>
<li>Pros: Non-flammable, environmentally friendly, low VOC</li>
<li>Cons: Slower evaporation, longer spray-to-close time</li>
<li>Best for: General injection molding, molds under 100 degrees C</li>
<li>Tip: Pre-heat mold to 60-80 degrees C before spraying</li>
</ul>

<p><strong>Solvent-Based Release Agents</strong></p>
<ul>
<li>Pros: Fast evaporation, excellent wetting on complex geometries</li>
<li>Cons: Flammable, VOC compliance needed, higher cost per application</li>
<li>Best for: Deep-draw parts, high-temperature molds, critical surface finish</li>
<li>Tip: Ensure adequate ventilation during application</li>
</ul>

<p><strong>Dry Film (PTFE/MoS2) Release Agents</strong></p>
<ul>
<li>Pros: Multiple-release coating (5-20 shots per application), no transfer to parts</li>
<li>Cons: Requires clean mold surface, periodic reapplication</li>
<li>Best for: High-production runs, rubber molding, structural foam</li>
<li>Tip: Apply by misting not soaking</li>
</ul>

<p><strong>Cost per 1000 shots:</strong></p>
<ul>
<li>Water-based: approx 8-15 USD</li>
<li>Solvent-based: approx 12-25 USD</li>
<li>Dry film: approx 5-10 USD (spread over releases)</li>
</ul>

<p>Water-based agents are gaining market share due to environmental regulations. Many molders keep both types on hand for different applications.</p>

<p>Which type works best for your shop?</p>

<hr>
<p>你们厂里是怎么处理的？来评论区聊聊。</p>